Hitec Prism 7 transmitters
transmitter, nor will it void your warranty. However, do not attempt this procedure
unless you are comfortable with soldering electronic equipment!
2. Remove 6 screws and open the back cover of the transmitter.
3. Remove 3 screws holding the microcomputer board, flip it over, and solder a small jumper wire across the diode,
4. Reassemble the transmitter, being careful not to pinch any
wires. Replace the antenna.
5. Plug your SIRIUS CHARGE into the transmitter charging jack. The green TX LED will light on SIRIUS
CHARGE, indicating "charging".